Accurl high quality 60tons/2000mm servo electric press brake machine 

The eB-Brake features the advantages of high acceleration, deceleration and fast response times of the servo-electric drive system. Compared toconventional press brakes considerable productivity increase can be reached; reduction of cycle times by up to 30 % and more is the reality.

Working speed is programmable to ensure bending is made without loss of product quality or operator safety. Lazer Safe’s IRIS System provides safe high speed closing down to just 2 mm. Compared with other guarding systems or even unguarded machines, the block laser system can save up to 2 or more seconds per cycle.Fast positioning speeds ensure the back gauge will be ready when the part is presented for each operation.

Different machines can have different maximum speed (fast approaching speed) but this does not have direct influence in bending time cycle. Time cycle of eB-Brake is always the best even if compared to a machine that on the catalogue seems to be fast; the excellent dynamic and total absence of dead phases makes the difference.Here a direct comparison among different press brake.

Product features

1, large load, large stroke, high precision and high efficiency bending

2, full automation 24 hours processing automatic feeding and unloading, automatic bending flexible, different sizes, the process of plate easy operation with a robot

3, the use of 7-axis (6-axis + mobile axis) robot, only one can carry out the workpiece machine into, positioning, folding capacity, expand the processing range

4, according to the processing products automatic replacement clip

Advantages:

1.energy-saving significantly

One of the advantages of electric servo drive technology is that the input power of the motor is proportional to the size of the load power.The power consumption of the slider is small when it is not loaded, and the power consumption of the slider is basically zero when it is stopped.  

2.Environmental friendly and pollution-free

Pure electric servo bending machine does not need hydraulic oil, there is no trouble to replace hydraulic oil and remove hydraulic components.There is no leakage of hydraulic oil during the replacement process and the system, no waste oil treatment and pollution

3.The slide speed is fast and the production efficiency is high

The response speed of servo motor is faster than that of hydraulic servo.The pressure machine between the impact of the environment and the hydraulic system heat, need to start warm up to the shutdown number of heat;Hydraulic system I and there are problems, direct search to eliminate the technical requirements of high, long time.However, the pure electric bending machine has few components and low failure rate.Therefore, the processing efficiency of pure electric servo bending machine is nearly twice as high as that of hydraulic bending machine of the same tonnage.